Hi all, I've been trying to connect an ENC28J60 ánd an SD cardreader module to an Arduino Nano on the SPI bus. Both modules work fine but only when the other module is not connected. Then I found this: SOLVED. Nrf24 (Mirf lib) + Micro SD-card works OK together I'm pretty sure I have the same problem. The SD card module is probably not playing nice on the SPI bus. The thread is marked as "SOLVED" but not really. What I've tried: -- desoldering an SMD pin en bridging it, that ended in one
Web-Enable your Arduino with an Arduino ENC28J60 Ethernet shield
Arduino (Nano), ENC28J60 and SD Card Reader - Project Guidance - Arduino Forum
Arduino Ethernet Shield ASX00008 MKR - Shield for Botland - Robotic Shop
Concatenate Float w/ a String - Programming Questions - Arduino Forum
Arduino UNO + Ethernet module (ENC28J60) - Wchih library to control the LEDs - IDE 1.x - Arduino Forum
Implementation for Microchip ENC28J60 Ethernet controller - Libraries - Arduino Forum
new library UIPEthernet: uIP adapted to Arduino for ENC28J60 - Networking, Protocols, and Devices - Arduino Forum
ROM-Reader for Super Nintendo / Super Famicom Game Cartridges - Exhibition / Gallery - Arduino Forum
Grove - Base Shield for Arduino Nano Botland - Robotic Shop
Arduino Nano Motor Carrier - motor driver for Arduino Nano 33 IoT - ABX00041 Botland - Robotic Shop
Arduino Ethernet - Pulling data from your Arduino
Ethernet 10/100 Mb/s - UART Converter for Raspberry Pi Pico - Waveshare 20410 Botland - Robotic Shop
ENC28J60 + EtherCard.h + Arduino Nano = Fail [Solved!] - Networking, Protocols, and Devices - Arduino Forum